55
Solution:
1.
In [Advanced Settings] for the custom paper in use, select [20: Transfer
Timing Roller Feed Speed Adj].
2.
Check the present value. Is it higher than +0.5% ?
Yes
No further improvement is likely. Contact your service representative.
No
Increase the value by 0.1 percentage points.
3.
Print the image. Is the problem resolved?
Yes
Finished!
No
Repeat Steps 1 to 3. If the problem persists even though you have
increased the value to +0.5%, contact your service representative.
To Next Page
Loading...
Need help?
General
