60
Procedure 1: Increasing the paper transfer current in full color mode
1.
In [Advanced Settings] for the custom paper in use, select [32: Paper
Transfer Current: FC].
2.
Increase the value by 5 μA.
3.
Print the image. Is the problem resolved?
Yes
Go to the next step.
No
Increase the value by 5 μA.
4.
Repeat Step 3. If the problem persists, contact your service representative.
5.
Is the density uneven?
Yes
Carry out Procedure 2, "Increasing the paper transfer current applied
to the side 2 of the paper in full color mode".
No
Finished!
Procedure 2: Increasing the paper transfer current applied to the side 2 of the
paper in full color mode
1.
Is the side 1 density uneven?
Yes
No further improvement is likely. Contact your service representative.
No
Go to the next step.
2.
In [Advanced Settings] for the custom paper in use, select [34: Paper
Transfer Current; Side 2: FC].
3.
Increase the scaling factor by 10 percentage points.
Example: If the present value is 100%, change it to 110%.
4.
Print the image. Is the problem resolved?
Yes
Finished!
No
Increase the value by 10 percentage points.
5.
Repeat Step 4. If the problem persists, contact your service representative.
To Next Page
Loading...
Need help?
General
