78
When printing on one side only
<If it is acceptable for the image to be incompletely printed at its edge>
Trim the image at its leading edge to increase the margin.
1.
In [Advanced Settings] for the custom paper in use, select [13: Adjust Erase
Margin of Leading Edge] and increase the value by 0.5 mm.
2.
Print the image. Is the problem resolved?
Yes
Finished!
No
Keep increasing the value by 0.5 mm until the problem is resolved.
If the problem persists even though the setting has reached its
maximum value, contact your service representative.
<If it is not acceptable for the image to be incompletely printed at its edge>
1.
In [Advanced Settings] for the custom paper in use, select [08: Adj Image
Position of Side1 With Feed] and increase the value by 0.5 mm.
2.
Print the image. Is the problem resolved?
Yes
Finished!
No
Keep increasing the value by 0.5 mm until the problem is resolved.
If the problem persists even though the setting has reached its
maximum value, contact your service representative.
To Next Page
Loading...
Need help?
General
