82
Sheets of mixed type, thickness, or color are loaded in the paper tray.
Load identical sheets in the paper tray.
When printing from a tray containing sheets of mixed color, you can prevent
paper misfeeding by specifying the following settings:
1.
In the [Adjustment Settings for Skilled Operators] menu, set [0107:
Deactivate Image Position Adjustment Across Feed Dir] to [On].
2.
Set [0108: Skew Detection] to [Off].
Colored paper or transparencies are loaded in the paper tray.
Paper edges may not have been detected correctly.
Adjust the color paper edge detection.
1.
Make a note of the present value in [06: Color Paper Edge Detection
Adjustment] in [Advanced Settings] for the custom paper in use.
2.
Increase the value in [06: Color Paper Edge Detection Adjustment].
3.
Print the image. Is the problem resolved?
Yes
Finished!
No
Keep increasing the value until the problem is resolved.
If the problem persists even though the setting has reached its
maximum value, restore the value noted in step 1 and go to the next
step.
4.
Decrease the value in [06: Color Paper Edge Detection Adjustment].
5.
Print the image. Is the problem resolved?
Yes
Finished!
No
Keep decreasing the value until the problem is resolved.
If the problem persists even though the setting has reached its
minimum value, restore the value noted in step 1 and go to the next
step.
6.
Set [12: Deactivate Image Position Adjustment] to [Activate].
7.
Print the image. Is the problem resolved?
Yes
Finished!
No
Contact your service representative.
To Next Page
Loading...
Need help?
General
