Procedure
D146/D147/D148/D149/D150 5-6 System Maintenance Section
Display contents
On the above screen, two programs, i.e., engine firmware and printer application are
displayed. (The screen may change depending on the firmware or application).
The display contents are as follows:
Display Contents
ROM: Display installed module number / version information.
NEW: Display module number / version information in the card.
* The upper row corresponds to the module number, the lower row corresponds to the
version name.
8. Select the module with the module selection button or 10 key operation. The selected module
is highlighted, and [Verify] and [Update] are displayed.
§ Depending on the combination of update software, it may not be possible to select
simultaneously.
Key or button operations
Keys or buttons to press Contents
[Update] or [#] key Update the ROM of the selected module.
[Verify] button or [./*] key Perform verification of the selected module.
9. Press the [Update] or [#] key, and perform software update.
10. During firmware update, a “firmware update/ verification progress screen" is displayed. When
firmware update is complete, a “firmware update end screen" is displayed.
To Next Page
Loading...
