Error screens during updating
D146/D147/D148/D149/D150 5-10 System Maintenance Section
Code Contents Solutions
33 Card version is not correct.
ROM data in the SD card is incorrect or
damaged.
34
There is no module which
matches the destination.
Re-enter ROM update data with correct
destination (domestic/overseas/OEM) in
the SD card.
35
There is no module
corresponding to the module.
Re-enter ROM update data for the correct
device in the SD card.
36
For another reason, there is
no rewrite target module.
Re-enter ROM update data for the correct
device in the SD card.
40
Motor download execution
malfunction
Re-enter the data in the SD card.
Alternatively, replace the engine circuit
board. Reinstallation required.
42
Control unit download
execution malfunction
Re-enter data in the SD card. Alternatively,
replace the control unit board.
Reinstallation required.
43
Print download execution
malfunction
Re-enter data in the SD card. Alternatively,
replace the HDD. Reinstallation required.
44
Controller download
execution malfunction
Re-enter data in the SD card. Alternatively,
replace the controller board. Reinstallation
required.
50
Electronic authentication
check NG
Re-enter ROM update data for the correct
device in the SD card.
§ The PDF firmware installed as standard contains a program required to print PS3 data as
default. However, this PS3 program is normally disabled.
§ The PS3 firmware is a dongle (key) which enables PS3 data printing functions. When the
PS3 firmware is installed, the PS3 program in the PDF firmware is enabled. Due to this
specification, the self-diagnosis result report shows the ROM part number/software
version of the PDF firmware contained in the PS3 program.
To Next Page
Loading...
