Ricoh D146 - Page 762

Main SP Tables-1
System Maintenance Section 2-43 D146/D147/D148/D149/D150
SP Mode Tables
Do not change. paper through target temperature: special paper 1: BW:
pressure: low speed
1106 [Fusing Temp. Display]
001
Heat Center ENG [-10 to 250 / 0 / 1deg/step]
Display fusing temperature: Displays detect temperature of heating center
sensor.
002
Heat End ENG [-10 to 250 / 0 / 1deg/step]
Display fusing temperature: Displays detect temperature of heating edge
sensor.
003
Press Center ENG [-10 to 250 / 0 / 1deg/step]
Display fusing temperature: Displays detect temperature of pressuring edge
sensor.
004
Press End ENG [-10 to 250 / 0 / 1deg/step]
Display fusing temperature: Displays detect temperature of pressuring edge
sensor.
005
Press End ENG [-10 to 250 / 0 / 1deg/step]
Display fusing temperature: Displays detect temperature of pressuring
extension edge sensor.
1107 [Standby Target Temp. Setting]
001
Stanby/Preheat1:Center *ENG [0 to 200 / 90 / 1deg/step]
Do not change. Ready/pre-heat 1 target temperature: center
003
Preheat2:Center *ENG [0 to 200 / 90 / 1deg/step]
Do not change. Pre-heat 2 target temperature: pressure
005
Low Power:Center *ENG [0 to 200 / 60 / 1deg/step]
Do not change. Energy save target temperature: pressure