Documents are sent and received between devices that support IP-Fax. Connect the devices via an IP
network (a network that uses TCP/IP as the communication protocol) to send documents. Specify the
destination by entering the IP address, host name or Own Fax No. according to the connection
environment. You can use this function to send and receive faxes between the machine and an other
manufacturer's device that supports IP-Fax.
Sending Documents by IP-Fax
You can reduce communication costs because no call charges are incurred.
You can communicate faster over an IP network compared to an analog phone line. Also, it does
not require an e-mail server to relay the message, so you can send and receive documents
without any delay.
This function is suitable for communicating between devices in the same local area network such
as your company intranet.
You can send a fax to a G3 fax by relaying the communication from the machine through a VoIP
gateway to a public telephone line.
IP-Fax supported by this machine is ITU-T Recommendation T.38 compliant.
To send to a G3 fax via a gateway connected to a public telephone line, you must specify it's the
receiver's machine telephone number. For example, if the receiver's fax number is "0312345678",
specify "5678". To send from an IP-Fax to G3 fax without using gatekeeper or SIP server, you
must register the gateway also.
An alias telephone number is a number that is registered in the gatekeeper, and is available only
in the network to which the gatekeeper is connected.
Pay attention to the number of telephone number digits set in the gateway/IP address conversion
table to avoid transmission error.
To Next Page
Loading...
