9
M 320
1. Check that the router (access point) is working correctly.
2. Make sure the wireless LAN option is attached to the
machine and the wireless (Wi-Fi) connection is enabled.
For details, see page 6 "Attaching the wireless LAN option".
3. Press the [
] or [ ] key to select [Network Setup], and then
the [OK] key.
12
Network Setup
Quit Setup
4. Press the [ ] or [ ] key to select [Wireless (Wi-Fi)], and
then the [OK] key.
Network Wizard
12
Wired (Ethernet)
Wireless (Wi-Fi)
5. Press the [ ] or [ ] key to select SSID of the router (access
point) from the searched SSID list, and then press the [OK]
key.
113
Network 2
Network 3
Network 1
The next steps differ depending on the authentication method
that you have selected. Proceed to Step 6 of the appropriate
section.
• If the authentication method is set to [WPA2-PSK] or [Mixed Mode
WPA2/WPA]
• If the authentication method is set to [Open system] or [Shared Key]
• If the authentication method has not been configured, proceed to
Ste p 7.
Connecting to devices using the WPA2-PSK or
Mix Mode WPA2/WPA authentication
6. Enter the encryption key using the number keys, and then
press the [OK] key.
WPA2-PSK
(8-63 chars/64 hex)
Key :
As the passphrase, you can enter either 8 to 63 ASCII
characters (0x20-0x7e) or 64 hexadecimal digits (0-9, A-F, a-f).
For details about checking the encryption key, see "Checking the
SSID and Encryption key".
7. Press the [OK] key.
(OK/Back)
Are you sure to connect?
8. Check the result.
Connection has succeeded:
Connect succeed!
Connection has failed:
Connect failed!
9. Press the [ ] or [ ] key to select [Quit Setup], and then the
[OK] key.
10. Press the [
] or [ ] key to select [Yes], and then the [OK]
key.
Network Wizard
Do not auto display
Menu from next time
Yes No
11. Configuring the Wireless (Wi-Fi) settings is complete.
To use the printer driver, install the printer driver
according to the procedure on page 19 "4. Installing the
Printer Driver".
To Next Page
Loading...
Need help?
General
Weight and Dimensions
