Ricoh MP C3003 User Manual

Category Item Settings
Security Device Certificate
Certificate 1
Request
Configure this to create the request form
for the certificate authority to issue the
device certificate.
If you are using a self-signed device
certificate, you do not need to configure
this setting.
Of the settings for the device certificate
(certificate issued by the certificate
authority), set "Algorithm Signature" to
one of the following:
• sha512WithRSA-4096
• sha512WithRSA-2048
• sha256WithRSA-4096
• sha256WithRSA-2048
• sha1WithRSA-2048
• sha1WithRSA-1024
Submit the application form to request
that the certificate authority issue the
device certificate.
The request method depends on the
certificate authority. For details, contact
the certificate authority.
You can install the certificate issued by
the certificate authority via Web Image
Monitor.
Security Device Certificate Install To use the device certificate (issued by
the certificate authority), install the
certificate by configuring this setting.
If using the intermediate certificate as
well, install that too.
Security Device Certificate
Install Intermediate
Certificate
When using an intermediate certificate,
configure this setting to install the
certificate.
Preparation for Use
25

Ricoh MP C3003 Specifications

General

Print Technology	Laser
Print Speed	30 ppm (Black/Color)
Max Print Resolution	1200 x 1200 dpi
Scan Resolution	600 x 600 dpi
Hard Disk Drive	250 GB
Monthly Duty Cycle	75, 000 pages
Duplex Printing	Yes
Copy Speed	30 cpm (Black/Color)
Type	Color Multifunction Printer
Copy Resolution	600 x 600 dpi
Max Paper Size	A3
Paper Capacity	4, 700 sheets
Connectivity	USB, Ethernet
Functions	Print, Copy, Scan, Fax
Paper Size	A4, A5, Legal, Letter, Executive
Warm-up Time	20 seconds
Dimensions	587 x 685 x 913 mm (with ARDF)