When a user cannot be registered
Message Cause Solution
"Auto-registration of user
information has failed."
Automatic registration of
information for LDAP
Authentication or Windows
Authentication failed
because the Address Book is
full.
For details about automatic registration
of user information, see "Auto
Registration to the Address Book",
Security Guide.
"Information for user
authentication is already
registered for another user."
The user name for LDAP was
already registered in a
different server with a
different ID, and a
duplication of the user name
occurred due to a switching
of domains (servers), etc..
For details about user authentication,
see "Configuring User Authentication",
Security Guide.
When other errors occur
Message Cause Solution
"85: Error" The specified graphics
library is unavailable.
Check that the data is valid.
"98: Error" The machine could not
access the hard disk
correctly.
Turn off the power, and then back on
again. If the message appears
frequently, contact your service
representative.
"99: Error" This data cannot be printed.
The specified data is either
corrupt or it cannot be
printed from a memory
storage device using the
Direct printing function.
Check that the data is valid. For details
about the kinds of data that can be
printed from a memory storage device
using the Direct printing function, see
"Direct Printing from a Memory
Storage Device", Print.
10. Troubleshooting
174
To Next Page
Loading...
Need help?
General
