Ricoh MP C4503

Technical Bulletin PAGE: 7/11
Reissued: 26-Dec-16
Model: MET-C1ab
Date: 18-Jun-13
No.: RD147002x
Version
Modified Points or Symptom Corrected
Management > Basic Auth., AND
- UP mode > system setting > Administrator tools > Extended Security >
Authenticate current job > Access privilege, AND
- UP mode > system setting > Administrator tools > Stop key to suspend print job
> All print job
Other changes:
4. SP5199 can be used to enable or disable paper exit from the finisher without
stapling.
1.13
Symptom corrected:
1. SC899 occurs the second time a name is searched via the LDAP server.
2. SC899 occurs when creating a searchable PDF document.
3. Lower productivity with authentication prints using paper folding.
4. SC998 occurs when a print request is generated in the machine transitioning back to
fusing unit off mode from sleep mode.
5. The UI for the double feed detection setting appears in System Settings, even
though this model does not have this function.
6. Alert notifications might be sent out even if the alert is cancelled before being
generated.
7. Machine stall when performing a scan from Web browser application or machine
error due to memory shortage
1.12
Spec changes:
Firmware modification (Engine and System/Copy) so that the power line (24V) is shut
down when detecting the layer short-circuit and SC code is displayed.
Note:
SC666 has been newly added. Depending on the sub code of SC666, the action is
different as follow.
SC666-01 ：PCB:IOB:ENGINE
SC666-02/03 ：PCB:IOB:TRANSPORT
SC666-00 ：Both PCB:IOB:ENGINE and TRANSPORT
IMPORTANT: To apply the above changes, update this firmware together with Engine
V1.29:08 (D1475503) or newer.
1.11
Specification Changes:
1. Supports CDN (Contents Delivery Network).
Symptom corrected:
1. Machine cannot recover from Energy Saver mode.
2. SC998 occurs when the machine is prompted (e.g. by a print job or other operation)
to recover from Energy Saver mode.
3. The machine hard disk can now be used by applications displayed on the Smart
Operation Panel.
4. SC672-11 (Controller start up error) occurs when the machine is prompted (e.g. by a
print job or other operation) to recover from Energy Saver mode.
5. SC899 occurs if the main power switch is turned off before the application has
completely booted up.
6. The message displayed in WIM when the paper is loaded incorrectly was changed
as follows: