Technical Bulletin PAGE: 2/2
Reissued: 26-Dec-16
Modified Points or Symptom Corrected
- In Web Image Monitor: Device Management > Configuration > Printer > Basic
Settings > Store and Skip Errored Job
This firmware is dependent on System/Copy firmware v1.23 (D1475575B) or later,
so please be sure to update it.
Other changes:
Support for the Portuguese orthography.
Symptom corrected:
1. Fixed incorrect Korean wording in Web Image Monitor.
2. Fixed the wording in the Device Certificate settings of the AirPrint function in Web
Image Monitor.
Other changes:
- Support for AirPrint.
This firmware is dependent on the following firmware modules. Please be sure to update
all of them:
- Printer firmware: v1.09 or later (D1655701M)
- Network Support firmware: v12.74 or later (D1475567M)
- PDF firmware: v1.06 or later (D1655733F)
- When Swedish or Traditional Chinese is selected as the display language in Web
Image Monitor, the incorrect wording might be shown in the UI.
Other Change:
- WIM message when paper is not set correctly in the right tandem tray is changed as
shown below.
Current message: "Reduce paper in the tray(s) to the limit mark and reset it correctly."
Modified Message: " Reduce paper in the tray(s) to the limit mark or reset it correctly."
- Support for Korean in Asia-Pacific models.
- When restoring an address book that was backed up by using an encryption key in
Web Image Monitor, the Restore function might not work correctly.
Other changes:
The following SP modes were added:
- SP5-101-104 (Low Power Mode)
- SP5-101-004 (Low Power Mode Timer Setting)