Ricoh MP C4503 - Page 82

Technical Bulletin PAGE: 2/4
Reissued: 22-Dec-16
Model: MET-C1ab_SOP
Date: 01-Aug-13
No.: RD147032q
Version
Modified Points or Symptom Corrected
- An SC899 error might occur when the RHPP port (port 59100) receives specific
data.
2.18
Symptom corrected:
When printing from an application that uses the SmartSDK interface, the number of
pages to be printed that is displayed in the application might be incorrect.
2.17
Symptom corrected:
Minor bug correction.
2.16
Other changes:
Support for the Portuguese orthography.
2.15
Symptom corrected:
SP1-103-002 fails, if paper type is set to plain paper 2 (default).
Note that this f/w must be used in combination with RPCS V3.13.28 or later.
2.14
Other changes:
Enabled administrators with rights to access "capability", "status", and "supportedPDL"
in the printer API (version 1.00 to 2.00).
Symptom corrected:
If a certain application is installed on the Smart Operation Panel, an SC899 error might
occur when the device is recovering from sleep mode.
2.13
Symptom corrected:
1. Cancelling the process of previewing a document on the operation panel might take
a significant amount of time.
2.12
Other changes:
1. Support for AirPrint.
This firmware is dependent on the following firmware module. Please be sure to update
it:
- Network Support firmware: v12.90 or later
- Web Support firmware: v2.06.1 or later
- PDF firmware: v1.06 or later
2. When printing a .tiff document from a removable storage device, the pages of the
document might be rotated 90 degrees or 270 degrees depending on the
orientation of the paper set in the device tray.
2.11
Symptom corrected:
- The specific combination of "Duplex/Booklet" and "Bypass Tray" might not be
selectable from the settings in the SDK application even though the combination is
supported.
- A print job conducted from Ricoh Smart Device Print&Scan via Enhanced Locked
Print NX FS v2 cannot be printed.
- While printing a job by using Enhanced Locked Print NX v2, the following jobs
cannot be spooled on the device. Because of this, the data-in LED does not blink
until all of the pages from the current job have finished printing.
- The printer API might encounter an error state and send data that is different from
the actual state of the printer. This occurs when the printer status level is "Warning"
and when the printer status is retrieved by the printer API.
- Printing back-to-back jobs by using Enhanced Locked Print NX v2 might cause an
SC997 error.