Ricoh MP C4503 - Page 83

Technical Bulletin PAGE: 3/4
Reissued: 22-Dec-16
Model: MET-C1ab_SOP
Date: 01-Aug-13
No.: RD147032q
Version
Modified Points or Symptom Corrected
- When the device runs out of paper, a wrench icon that represents an SC error might
appear in the "System" column in Web Image Monitor.
2.10
Specification Change
- Supports Web application API V.1.01 (CSP/GPS/MediaPrint:TIFF).
Other changes:
- Supported APIs for web applications v1.01.
2.09
Symptom corrected:
1. Fixed: The Compulsory Security Stamp is not printed under the following conditions:
- "Compulsory Security Stamp: Printer" is enabled in the Administrator Tools of
System Settings.
- The printer displays one of the following languages: Simplified Chinese,
Traditional Chinese, Korean, Thai, Hebrew, Arabic, or Turkish.
(GFPR#RA13100005)
2. A specific combination of Staple and Punch or Staple and Duplex/Booklet cannot be
selected from the SDK application even though the combination is supported.
3. A specific combination of Staple and Punch or Staple and Duplex/Booklet can be
selected from the SDK application even though the combination is not supported;
however, the selected configuration is not applied.
4. The API for web applications might not work when the password for a PDF file
contains more than 33 characters.
Other changes:
SP5-490-001 (MF Key Card: Job Permit Setting) is now available.
Note: Previously, this SP could only be used on machines sold in Japan.
2.08
Symptom corrected:
1. When an A4-size document is printed from the bypass tray while the printer is in
Low Power Mode, the setting "Paper Confirmation for Bypass Tray" is configured to
"Display", and A4 paper is set to LEF in the bypass tray, a paper jam occurs.
2. The document title overflows from the Printer home screen and Job operation
screen on the operation panel when printing if the title of the document is longer
than 27 bytes and the 25th character is not a double-byte character.
2.07
Symptom corrected:
1. The printer might stall when one of the following is performed:
- Printing without storing jobs that contain exclusions when using the "Card
Authentication Package V2", "Enhanced Locked Print NX V2", "Card
Authentication Package Enterprise Server V2", or "Enhanced Locked Print NX
Flex Server V2" setting.
- Printing a webpage from the browser on the operation panel.
2. Printing with Front Cover enabled and using a combination of duplex printing and
the Bypass Tray might cause the pages to be printed in the incorrect order.
3. Printing back-to-back jobs to the Bypass Tray might cause a paper mismatch error
after three jobs have been printed.
2.06
Other Changes:
A touch screen function was added to the preview screen.
IMPORTANT:
To apply the above change, in addition to this firmware, make sure to update
System/Copy firmware to Ver.2.24 or later and the LegacyUI firmware to Ver.1.19 or
later.