Ricoh MP C6502SP - Page 309

013
RFU Timing *CTL
[0 or 1 / 1 / 1/step]
0: Any status of a target machine
1: Sleep or panel off mode only
Selects the timing for the remote firmware updating.
014
RCG Error Cause CTL
[0 or 1 / 0 / 1/step]
0: Initial state, normal condition
1: Error
Displays RCG connection error. cause
021
RCG-C Registed *CTL
[0 or 1 / 0 / 1/step]
0: Installation not completed
1: Installation completed
This SP displays the RCG-N installation end flag.
023
Connect Type (N/M) *CTL
[0 or 1 / 0 / 1/step]
0: Internet connection
1: Dial-up connection
This SP displays and selects the RCG-N connection method.
061
Cert Expire Timing *CTL [0 to 0xffffffff / 0 / 1/step]
Proximity of the expiration of the certification.
062
Use Proxy *CTL
[0 or 1 / 0 / 1/step]
0: Not use
1: Use
This SP setting determines if the proxy server is used when the machine communicates with
the service center.
SP5-722 to 998 (Mode)
307