041
Fill Addr Acl Info *CTL
[- / - / -]
[Execute]
This SP must be executed immediately after installation of an HDD unit in a basic machine
that previously had no HDD. The first time the machine is powered on with the new HDD
installed, the system automatically takes the address book from the NVRAM and writes it
onto the new HDD. However, the new address book on the HDD can be accessed only by
the system administrator at this stage. Executing this SP by the service technician
immediately after power on grants full address book access to all users.
Procedure
1.
Turn the machine off.
2. Install the new HDD.
3. Turn the machine on.
4. The address book and its initial data are created on the HDD automatically.
5. However, at this point the address book can be accessed by only the system
administrator or key operator.
6. Enter the SP mode and do SP5846-041. After this SP executes successfully, any user
can access the address book.
043
Addr Book Media *CTL
[0 to 30 / 0 /1/step]
0: Unconfirmed
1: SD Slot 1
2: SD Slot 2
3: SD Slot 3
4: USB Flash ROM
10: SD Slot 10
20: HDD
30: Nothing
Displays the slot number where an address book data is in.
046 Initialize All Setting & Addr Book CTL
[- / - / -]
[Execute]
047
Initialize Local Address Book CTL
[- / - / -]
[Execute]
Clears the local address book information, including the user code.
3. Main SP Tables-5
336
To Next Page
Loading...
