bit 0
Show "Collate Type", "Staple Type" and "Punch
Type" buttons on the operation panel.
Disabled Enabled
If enabled, users will be able to configure a Collate Type, Staple Type, and Punch
Type from the operation panel. The available types will depend on the device and
configured options.
After enabling the function, the settings will appear under:
"User Tools > Printer Features > System"
bit 1 Multiple copies if a paper size or type mismatch
occurs
Disabled
(single
copy)
Enabled
(multiple)
If a paper size or type mismatch occurs during the printing of multiple copies, only a
single copy is output by default. Using this BitSw, the device can be configured to
print all copies even if a paper mismatch occurs.
bit 2 Prevent SDK applications from altering the contents
of a job.
Disabled Enabled
If this switch is enabled, SDK applications will not be able to alter print data. This is
achieved by preventing SDK applications from accessing a module called the "GPS
Filter".
Note: The main purpose of this switch is for troubleshooting the effects of SDK
applications on data.
bit 3 [PS] PS Criteria Pattern3 Pattern1
Change the number of PS criterion used by the PS interpreter to determine whether a
job is PS data or not.
Pattern3: includes most PS commands.
Pattern1: A small number of PS tags and headers
bit 4
Increase max number of stored jobs.
Disabled
(100)
Enabled (750)
Changes the maximum number of jobs that can be stored on the HDD. The default
(disabled) is 100. If this is enabled, the max. will be raised to 750.
bit 5
Face-up output Disabled
Enabled
(Face-up)
All print jobs will be output face-up in the destination tray.
8. Printer SP Mode
808
To Next Page
Loading...
Need help?
General