Gate Fold
L3
L2
L1
Paper feed direction
CEZ537
The mark indicates the leading edge (relative to the paper feed direction), and the mark indicates
the trailing edge.
<How to adjust the folding deviation>
This procedure is the same for L1, L2, and L3.
1. Open the front cover of the multi-folding unit.
2. Remove the mounting screw.
If the mounting screw is attached to the adjusting screw hole, unfasten it.
3. Turn the adjusting screw to adjust the deviation.
• To increase the length at the bottom part of paper, turn the screw clockwise.
• To decrease the length at the bottom part of paper, turn the screw counterclockwise.
4. Attach the mounting screw to fasten the adjusting screw.
If the mounting screw is attached to the adjusting screw hole, fasten it.
5. Close the front cover of the multi-folding unit.
• For multi-sheet folding, folding deviations of the innermost sheet will be adjusted.
5. Post-Processing Option Troubleshooting
160
To Next Page
Loading...
