No. Item Description
049 [Contact Movement of Ppr
Trns in Low Pressure]
Adjust the secondary transfer nip pressure when 045:
[Ppr Trns Contact Mode] is set to [Low Pressure].
032 [Textured Paper Mode] Specify whether or not to enable Textured Paper mode.
033 [Textured Paper Mode
Voltage: BW: Side 1]
Adjust the voltage applied to the paper for paper transfer
when printing in each print mode (color/black-and-
white, one-side/duplex) with Textured Paper mode
enabled.
034 [Textured Paper Mode
Voltage: BW: Side 2]
035 [Textured Paper Mode
Voltage: FC: Side 1]
036 [Textured Paper Mode
Voltage: FC: Side 2]
Fuser Adjustment
For details about the following items, see page 141 "Fuser Adjustment".
No. Item Description
050 [Fusing Temp] Adjust the heat roller temperature.
051 [Fusing Pressure Roller
Temp]
Adjust the pressure roller temperature.
052 [Fusing Nip Width Setting] Adjust the nip width between the fusing belt and pressure
roller.
053 [Fusing Temp to Feed Ppr] Adjust the fusing temperature at which to allow paper
feeding after warming up.
054 [Additional Fusing Temp
1]
Adjust the fusing unit's accumulated temperature for a
specific time after a job starts.
055 [Additional Fusing Temp
2]
Adjust the fusing unit's accumulated temperature for a
specific time after writing starts.
056 [Cleaning Web Rotation
Interval]
Specify the interval between each activation of the
cleaning web.
057 [Cleaning Web Contact
Position]
Specify how the cleaning web comes into contact and
separates.
Menu Items and Functions
109
To Next Page
Loading...
