Ricoh PRO C7200X

• Special color mode is available for Pro C7200X, Pro C7210X, Pro C7200SX, and Pro C7210SX.
• To adjust the following settings, pre-register the type of paper in use as a custom paper. For details
about registering custom papers, see "Specifying a Custom Paper", Preparation.
Solution:
1. In the [Machine: Maintenance] group on the [Adjustment Settings for Operators], check
0515: [Temperature / Humidity Outside]. Is the temperature 10°C or higher? Is the
humidity 15% or higher?
Yes Go to the next step.
No Skip to Step 8.
2. Are you using Paper Weight 4 (105.1 g/m2 or higher)?
Yes Register the paper in the custom paper profile.
No Skip to Step 8.
3. In [Advanced Settings] for the custom paper you are using, set 1218: [Paper Transfer
Output: Textured Paper Mode] to [On].
4. Select 1231: [Print Speed], and then set the value in the following corresponding settings
to [Low].
• [BW/FC/FCS]
[BW/FC/FCS]
• [FCS]
[Clear/Special], [White]
• [S]
[Clear/Special], [White]
• [BW/FC/FCS: Fuser Setting HQ]
[BW/FC/FCS]
• [FCS: Fuser Setting HQ]
[Clear/Special], [White]
• [S: Fuser Setting HQ]
[Clear/Special], [White]
5. Print the image.
7. Image Quality Problem: Full Page
114