Cause:
This may occur if:
• Printing is done at high temperature or humidity
• Printing solid fills
• Slippery paper is used
• Printing on small size of paper
• To adjust the following settings, pre-register the type of paper in use as a custom paper. For details
about registering custom papers, see "Specifying a Custom Paper", Preparation.
• Dropouts (character voids) do not occur on the first sheet.
Solution:
(a) Adjusting the image density
1. Launch Fiery Command WorkStation 6.
2. Click [Job Properties] corresponding to the image to be printed.
3. Click the [Color] tab.
4. Click [General Settings] or [Expert Settings].
5. Check the setting value in "Gray and Black (CMYK and RGB)". Is it "ColorWise Off"?
Yes Go to the next step.
No Proceed to Step 7.
6. Ensure that "Gray and Black (CMYK and RGB)" is not set to [ColorWise Off].
When printing a highly dense image or one that requires a large amount of toner, in the [Job
Properties] [Image] tab, select [Toner Reduction].
7. Print the image. Has the problem been resolved?
Yes Finished!
No Go to the next step.
8. In the [Machine: Image Quality] group on the [Adjustment Settings for Operators] menu,
select 0201: [Execute Image Quality Adjustment] and execute [Adjust Image Density].
9. Print the image. Has the problem been resolved?
Yes Finished!
Unprinted
121
To Next Page
Loading...
