Ricoh PRO C7200X

• [BW/FC/FCS: Fuser Setting HQ]
[BW/FC/FCS]
• [FCS: Fuser Setting HQ]
[Clear/Special], [White]
• [S: Fuser Setting HQ]
[Clear/Special], [White]
3. Is the setting set to [Middle]?
Yes Proceed to "(b) Changing the fusing temperature (If [Print Speed] is set to
[Middle])".
No Proceed to "(c) Changing the fusing temperature (If [Print Speed] is set to [Low])".
(b) Changing the fusing temperature (If [Print Speed] is set to [Middle])
1. In [Advanced Settings] for the custom paper you are using, select 1232: [Fusing
Temperature], and then decrease the value in the following corresponding settings by
5°C.
• [BW/FC/FCS]
[Heat Roller Temp]
• [FCS]
[Heat Roller Temp: Clr/Sp], [Heat Roller Temp: White]
• [S]
[Heat Roller Temp: Clr/Sp], [Heat Roller Temp: White]
• [BW/FC/FCS: Fuser Setting HQ]
[Heat Roller Temp]
• [FCS: Fuser Setting HQ]
[Heat Roller Temp: Clr/Sp], [Heat Roller Temp: White]
• [S: Fuser Setting HQ]
[Heat Roller Temp: Clr/Sp], [Heat Roller Temp: White]
2. Print 5 or more A4 sheets. Has the problem been resolved?
Yes Finished!
No Carry out "(a) Changing the printing speed".
7. Image Quality Problem: Full Page
200