5. Print 10 or more A3 sheets. Are there wrinkles?
Yes Proceed to "(c) Decreasing the fusing temperature".
No Finished!
(c) Decreasing the fusing temperature
1. In [Advanced Settings] for the custom paper you are using, select 1232: [Fusing
Temperature], and then decrease the value in the following corresponding settings by
5°C.
• [BW/FC/FCS]
[Heat Roller Temp]
• [FCS]
[Heat Roller Temp: Clr/Sp], [Heat Roller Temp: White]
• [S]
[Heat Roller Temp: Clr/Sp], [Heat Roller Temp: White]
• [BW/FC/FCS: Fuser Setting HQ]
[Heat Roller Temp]
• [FCS: Fuser Setting HQ]
[Heat Roller Temp: Clr/Sp], [Heat Roller Temp: White]
• [S: Fuser Setting HQ]
[Heat Roller Temp: Clr/Sp], [Heat Roller Temp: White]
2. Print 10 or more A3 sheets.
3. Is the toner fusibility within the permissible range?
Yes Go to the next step.
No Contact your service representative.
4. Are there wrinkles?
Yes Repeat Steps 1 to 4.
No Finished!
• After performing the solution, it is recommended to perform the color calibration of the external
controller.
• Check the toner fusibility as follows:
Paper Feed Problems Affecting Image Quality
245
To Next Page
Loading...
