Solution:
1. In the [Machine: Maintenance] group on the [Adjustment Settings for Operators] menu,
select 0508: [Manually Smooth Fusing Belt], and then execute [Belt Scratches].
2. Print the image. Has the problem been resolved?
Yes Go to the next step.
No Repeat Steps 1 and 2. If the problem persists even after executing [Belt Scratches] 5
times, contact your service representative.
3. In [Advanced Settings] for the custom paper you are using, select 1243: [Fusing Belt
Smoothing], and then check the present value in [For Belt Scratches]. Is it [Off (Do not
Execute)]?
Yes Finished!
No Increase the value in [For Belt Scratches] by 1 level.
Vertical Glossy Line: Uneven Glossiness due to Wax Stain
Toner wax in the shape of the fuser belt smoothing roller stains the image.
Cause:
This may occur due to uneven wax adherence to the fuser belt.
• To adjust the following settings, pre-register the type of paper in use as a custom paper. For details
about registering custom papers, see "Specifying a Custom Paper", Preparation.
5. Image Quality Problem: Lines
60
To Next Page
Loading...
