No Contact your service representative.
Banding: Metallic Paper (Random Pitch)
When printing on metallic paper, white streaks 5 to 40 mm long appear all over the paper
perpendicular to the paper feed direction.
Cause:
This may occur when printing on metallic paper.
• To adjust the following settings, pre-register the type of paper in use as a custom paper. For details
about registering custom papers, see "Specifying a Custom Paper", Preparation.
Solutions:
1. In [Advanced Settings] for the custom paper you are using, select 1214: [Paper Transfer
Output], and then adjust the values in the following settings in steps of ±1 according to the
mode in use.
• [BW]
[Side 1], [Side 2]
• [FC/FCS]
[Side 1], [Side 2]
• [FCS]
[Side 1], [Side 2]
• [S]
[Side 1: Clear/Special], [Side 1: White]
5. Image Quality Problem: Lines
74
To Next Page
Loading...
