Yes Finished!
No Go to the next step.
3. In [Advanced Settings] for the custom paper you are using, select 1231: [Print Speed],
and then set the value in the following corresponding settings to [Middle].
• [BW/FC/FCS]
[BW/FC/FCS]
• [FCS]
[Clear/Special], [White]
• [S]
[Clear/Special], [White]
• [BW/FC/FCS: Fuser Setting HQ]
[BW/FC/FCS]
• [FCS: Fuser Setting HQ]
[Clear/Special], [White]
• [S: Fuser Setting HQ]
[Clear/Special], [White]
4. Print the image. Has the problem been resolved?
Yes Finished!
No Contact your service representative.
Jitter: When Using Very Stiff Paper
When printing on very stiff paper, a streak appears in the area 280-300 mm from the leading edge of
the paper.
5. Image Quality Problem: Lines
76
To Next Page
Loading...
