Ricoh PRO C7200X

No Repeat Steps 3 and 4. If the problem persists even after increasing the heating
roller's temperature to 185°C, go to the next step.
5. Have changes to the settings resulted in glossy lines or paper misfeed?
Yes Reset the temperature, and then go to the next step.
No Go to the next step.
6. In [Advanced Settings] for the custom paper you are using, select 1231: [Print Speed],
and then set the value in the following corresponding settings to [Middle].
• [BW/FC/FCS]
[BW/FC/FCS]
• [FCS]
[Clear/Special], [White]
• [S]
[Clear/Special], [White]
• [BW/FC/FCS: Fuser Setting HQ]
[BW/FC/FCS]
• [FCS: Fuser Setting HQ]
[Clear/Special], [White]
• [S: Fuser Setting HQ]
[Clear/Special], [White]
7. Print 20 sheets of the image, then another 10. Does this eliminate the problem?
Yes Finished!
No Go to the next step.
8. Select 1231: [Print Speed], and then set the value in the following corresponding settings
to [Low].
• [BW/FC/FCS]
[BW/FC/FCS]
• [FCS]
[Clear/Special], [White]
• [S]
[Clear/Special], [White]
• [BW/FC/FCS: Fuser Setting HQ]
6. Image Quality Problem: Spots
88