Taurus-C1 Training
167
Slide 167
Docking the LCIT to the Machine
Push the LCIT close to the left side of the main machine.
On the left side of the main machine [1], check the height of the of
the LCIT paper exit [2].
Move the main machine entrance plate [3] up and down and
confirm that it does not contact the paper exit of the LCIT.
If the main machine entrance plate does touch the LCIT exit,
adjust the height of the LCIT.
This is a new procedure.
Height Adjustment: Service Manual > Installation > Common Adjustments
To Next Page
