Taurus-C1 Training
171
Slide 171
Common Procedures
Before you dock the peripheral, make sure that
you install the correct set of sponges.
If you dock a peripheral directly to the main
machine, the procedure is different from when
you dock the peripheral to another peripheral.
After installing each unit, do the following:
Set the leveling shoes and adjust the height of
the unit.
Load some B4 paper in the 2nd tray of the main
machine, and make several copies.
Check paper skew and side-to-side registration
and correct if necessary.
Height and Level Adjustment, Skew and Side-to-side
Registration: Installation > Common Adjustments
We will take a look at the common adjustments in more detail later.
The installation for the sponges is explained in the installation procedures for
each peripheral.
To Next Page
