Taurus-C1 Training
179
Slide 179
Installing the Cover Interposer
First, dock the transport unit of the cover
interposer to the copier.
Important: Do not put the tray unit on the top of the
cover interposer at this time.
Then, install the next device to the left of the
cover interposer.
Finally, attach the tray unit to the top of the cover
interposer.
The tray unit is supported by the cover interposer,
and the next unit to the left.
Do not attach the tray unit to the top of the cover
interposer until after you dock the next device to
the left of the cover interposer.
Installation > Cover Interposer Tray (D518)
To Next Page
