Taurus-C1 Training
241
Slide 241
Before Removing a PCDU
Lower the ITB release lever.
This separates the ITB from the bottoms of the drums, so that the
surface of the ITB or drum will not be scratched when a PCU is
removed.
When you take out a PCDU:
Place the PCDU upright on a flat clean surface.
There is only a small gap between the surface of the drum and the
table surface, so the surface must be smooth, flat, and clean.
To avoid damage to the surface of the drum, never place the
PCDU on a carpet or rough cloth.
No additional notes
To Next Page
