Taurus-C1 Training
295
Slide 295
Tandem Feed Tray
Paper Lift/Remaining Paper Detection
At the same time as the lift motor starts, the pick-up solenoid
lowers the pick-up roller.
When the lift sensor detects the actuator, the lift motor stops
When the tray is pulled out, the tray falls slowly (there is a
damper).
Pick-up
Solenoid
Lift Sensor
Damper
This slide shows what the pick-up roller mechanism is doing when the lift motor
starts up.
It also shows the base plate lowering mechanism.
However, it is not sufficient for the bottom plate to just drop under its own weight
when the tray is pulled out.
¾ The tray bottom plate must lower automatically before the stack in the left
side can move across.
The tray lift motor lowers the plate until the lower limit sensor detects the
actuator on the bottom plate.
Then the stack in the left side can move across.
To Next Page
