Taurus-C1 Training
34
Slide 34
PM Table
The basic PM interval for the main machine is 300k. Many parts are
replaced at 300k or at a multiple of 300k. Some important exceptions are:
Developer and development unit filters
» D074: 750K
» D075, M044: 900K
Drum *
» D074: 980K
» D075, M044: 1100K
ITB: 1600K
PTR Lubricant Bar *
» D074: 450K
» D075, M044: 500K
Fusing Unit *
» Fusing Belt, Hot Roller, Pressure Roller, Bearings, Thermistors, Lubrication of
Gears: 650K
Web cleaning unit *: 450K
Inspection and cleaning of all rollers is recommended every 100k. Replace
at 1000k.
Lubrication of fusing unit parts is required. The procedures are in the
Replacement and Adjustment section of the service manual.
See the PM tables in the service manual for details of PM intervals for all
parts, and for the peripherals, which have different schedules from the
main machine.
The development unit is not a PM item.
*: These components are part of units that can be replaced by TCRU trained
customers.
There will be more detail about TCRU procedures later in the course.
To Next Page
Loading...
