Taurus-C1 Training
54
Slide 54
Replacing the Used Toner Bottle
When the used toner bottle [1] is
full, it can be removed and
replaced with an empty bottle
while the machine is operating.
The reservoir [2] above the bottle
can continue to receive and hold
used toner while the bottle is out
of the machine.
A spring loaded stopper tightly
seals the toner port between
the reservoir and bottle when
the bottle is removed.
The bottle replacement is done
by the service technician (or an
operator if an empty toner bottle
is available).
However, the service technician
must remove the full bottle and
empty it at the service center.
If the reservoir starts to get full with the used toner bottle out of the machine, a
sensor detects this and the machine stops.
To Next Page
Loading...
