Taurus-C1 Training
5
Slide 5
Printer Model – Basic System
(1): Main Unit 1st Tray (1000 sheets x 2)
(2): Main Unit 2nd Tray (500 sheets)
(3): Optional A3/DLT LCIT 1st Tray (1000 sheets)
(4): Optional A3/DLT LCIT 2nd Tray (2000 sheets)
(5): Optional A3/DLT LCIT 3rd Tray (1000 sheets)
(6): Optional Bypass Tray (500 sheets)
(7): Optional Finisher (two different ones are available)
 This shows the printer model with minimal optional peripherals attached. The
only obvious difference from the copier is that there is no ARDF.
 The following are the same as for the copier model:
¾ Only one LCIT can be installed.
¾ There is no A4/LT LCIT option.
¾ Two finisher models are available: The D512 (corner stapling and booklet
stapling), and the D513 (corner stapling only).
The finisher (7) in the illustration above is the Booklet Finisher D512 .
To Next Page
Loading...
