Taurus-C1 Training
54
Slide 54
Replacing the Used Toner Bottle
 When the used toner bottle [1] is
full, it can be removed and
replaced with an empty bottle
while the machine is operating.
 The reservoir [2] above the bottle
can continue to receive and hold
used toner while the bottle is out
of the machine.
 A spring loaded stopper tightly
seals the toner port between
the reservoir and bottle when
the bottle is removed.
 The bottle replacement is done
by the service technician (or an
operator if an empty toner bottle
is available).
 However, the service technician
must remove the full bottle and
empty it at the service center.
 If the reservoir starts to get full with the used toner bottle out of the machine, a
sensor detects this and the machine stops.
To Next Page
Loading...
