135
<When letter folding is applied to a single sheet>
Note:
• This procedure is applied especially to coated paper.
• To adjust the following settings, pre-register the type of paper in use as a custom
paper. For details about registering custom papers, see "Registering a Custom
Paper", Paper Settings Reference.
1.
In [General Features] in [System Settings], set [Letter Fold-in Position] for a
single sheet to "7 mm".
2.
In [Advanced Settings] for the custom paper in use, select [59: Letter Fold-in
Position 1: Single-sheet Fold].
3.
Increase the value by 0.2 mm.
4.
Print the image. Is the problem resolved?
Yes
Finished!
No
Repeat Step 2 to 4. If the problem persists even though the setting
value is 4 mm larger than the maximum value, contact your service
representative.
To Next Page
Loading...
