29
3.
Adjust the setting for the side 2 of the paper. Configure the following settings
in [Advanced Settings] for the custom paper in use.
<Printing in black and white>
Increase the scaling factor by 5 percentage points in [33: Paper Transfer
Current; Side 2: B&W].
Example: If the present value is 100%, change it to 105%.
<Printing in full color>
Increase the scaling factor by 5 percentage points in [34: Paper Transfer
Current; Side 2: FC].
Example: If the present value is 100%, change it to 105%.
4.
Print the image. Is the problem resolved?
Yes
Finished!
No
Repeat Steps 1 to 4. If the problem persists, contact your service
representative.
To Next Page
Loading...
