Ricoh Pro C751EX - Page 60

60
Procedure 1: Increasing the paper transfer current in full color mode
1.
In [Advanced Settings] for the custom paper in use, select [32: Paper
Transfer Current: FC].
2.
Increase the value by 5 μA.
3.
Print the image. Is the problem resolved?
Yes
Go to the next step.
No
Increase the value by 5 μA.
4.
Repeat Step 3. If the problem persists, contact your service representative.
5.
Is the density uneven?
Yes
Carry out Procedure 2, "Increasing the paper transfer current applied
to the side 2 of the paper in full color mode".
No
Finished!
Procedure 2: Increasing the paper transfer current applied to the side 2 of the
paper in full color mode
1.
Is the side 1 density uneven?
Yes
No further improvement is likely. Contact your service representative.
No
Go to the next step.
2.
In [Advanced Settings] for the custom paper in use, select [34: Paper
Transfer Current; Side 2: FC].
3.
Increase the scaling factor by 10 percentage points.
Example: If the present value is 100%, change it to 110%.
4.
Print the image. Is the problem resolved?
Yes
Finished!
No
Increase the value by 10 percentage points.
5.
Repeat Step 4. If the problem persists, contact your service representative.