Feed the media to move the cut position,
check whether you can cut it or not.
• Open and close the center cover, and then check that the message on the control panel has disappeared.
• Feed the media to move the cut position, and then cut the media. If you cannot cut the media, proceed to the following procedure:
2. Check whether the positions of the media edges are correct.
• Open and close the center cover, and then check that the message on the control panel has disappeared.
• Check whether both edges of the media are inside the alignment scale on the platen.
• Match the media edges with the alignment scale, and then cut the media.
If you cannot cut the media, proceed to the following procedure:
3. Check whether you set the media to the roll-up unit.
• Set the media to the roll-up unit.
• Feed the media to move the cut position, and then cut the media.
Media is easier to cut when it is tense.
If you cannot cut the media, proceed to the following procedure:
4. Check whether you are using recommended media.
• Check whether it is recommended media.
See page 42 "About Media".
• Depending on the material, you might not be able to cut some of the recommended media.
When you cut media made of hard material or thick media, use a commercially available
Feed the media to move the cut position,
check whether you can cut it or not.
• Open and close the center cover, and then check that the message on the control panel has disappeared.
• Feed the media to move the cut position, and then cut the media. If you cannot cut the media, proceed to the following procedure:
2. Check whether the positions of the media edges are correct.
• Open and close the center cover, and then check that the message on the control panel has disappeared.
• Check whether both edges of the media are inside the alignment scale on the platen.
• Match the media edges with the alignment scale, and then cut the media.
If you cannot cut the media, proceed to the following procedure:
3. Check whether you set the media to the roll-up unit.
• Set the media to the roll-up unit.
• Feed the media to move the cut position, and then cut the media.
Media is easier to cut when it is tense.
If you cannot cut the media, proceed to the following procedure:
4. Check whether you are using recommended media.
• Check whether it is recommended media.
See page 42 "About Media".
• Depending on the material, you might not be able to cut some of the recommended media.
When you cut media made of hard material or thick media, use a commercially available
To Previous Page
Loading...
