CIP Training L5160/L5130
Additional Functions
CAUTION
If you enter an incorrect value, ink may be ejected onto the platen without the media. In
that case, clean the platen. For cleaning the platen, see the section "Cleaning the Platen"
in the manual "Requests for Daily Care and Maintenance".
When [Auto Detect Media Width] is set to [Off], set the right-side edge position and
width manually.
Press [Next] to set [Media Right Side
Edge Position] and [Media Width].
In [Media Right Side Edge Position], enter the position of the right-side edge of media with
a range of -10 to 10 of the scale on the po
st-heater.
If it is -4 on the post-heater scale, enter "-4".
To Next Page
Loading...
