CIP Training L5160/L5130
Additional Functions
In [Media Width], enter the media width a range of 297 to 1,626mm (approx. 11.7 to
64.0inches)(for RICOH Pro L5160) or 297 to 1,372mm(approx. 11.7 to 54.0inches)(for RICOH
Pro L5130).
Additional Drive Mode of Roll-Up Holder
Changing Roll-Up Drive Mode
[Overview]
This section explains the procedures for changing roll-up mode.
The machine can offer two roll-up modes for handling wide variety of media from thin films
to thick banners.
Basically, we recommend using "Inactive" drive mode, the default setting, unless there’s
problem on print quality and/or media feeding.
However, if the media has not been fed and does not come out from the media output
location (Cure Heater) and/or the media rises on the platen (see following figure), media
feeding behavior may be improved by selecting "Forced Wind" drive mode.
Please use roll-up holder and select appropriate drive mode for improving media misfeed
issues.
Fig. Photo and schematic illustration of risen media on the platen.
To Next Page
Loading...
