Added New Drying Operation
11
⚫ Execute Drying After Printing
Performs only the drying operation for the undried part of the printed image by following
the steps below.
Use this feature when you want to dry the undried part of the printed image without
printing the next job.
1. Press [Standard Procedure] key.
2. Press [Dry After Printing].
3. Press [Execute Drying After Printing]
4. Press [Execute]
Note:
- This feature does not work when the media is not set, when the heater setting are
"OFF", or until any printing is done after returning from sleep mode.
To Next Page
Loading...
