Ricoh Ri 100 - Page 2

1
Loading the fabric in the cassette
For details, refer to User’s Guide provided with the printer Ri 100.
You can shorten the processing time by putting a garment in the cassette while pre-
heating the finisher.
➊
Press the [Power] key to turn on the power.
➑
When you move the mode switching lever to the
left, processing starts. An alarm sounds after
preheating is completed.
➋
Make sure the mode switching lever is set in the
center.
➒
➌
Set the temperature of the heater.
Set the temperature according to the fabric on
which you are printing. The default setting is “High”.
❿
Confirm that the mode indicator light is off.
➍
When the [Preheat] key is lit, press the [Preheat]
key to start preheating.
When the [Preheat] key is unlit, no operation is
necessary because preheating is completed.
⓫
Press the [Stop/Unlock] key for 1 second or
more to open the cover. When set to the profes-
sional mode, it is not necessary to hold down
the [Stop/Unlock] key.
➎
Press the [Stop/Unlock] key for 1 second or
more to open the cover. When set to the profes-
sional mode, it is not necessary to hold down
the [Stop/Unlock] key.
⓬
➏ ⓭
➐
2
Smoothing wrinkles/flattening fibers (Press )