Ricoh Ri 100 - Page 3

3
Printing
For details, refer to User’s Guide provided with the printer Ri 100.
➊
Make sure the mode switching lever is set in the
center.
➑
➋
Set the temperature of the heater.
Set the temperature according to the fabric on
which you are printing. The default setting is
“High”.
➒
When you move the mode switching lever to the
right, processing starts. An alarm sounds after
preheating is completed.
➌
Set the amount of time that the heater is on.
Set the time according to the fabric on which
you are printing. The default setting is “Medium”.
❿
➍
When the [Preheat] key is lit, press the [Preheat]
key to start preheating.
When the [Preheat] key is unlit, no operation is
necessary because preheating is completed.
⓫
Confirm that the mode indicator light is off.
➎
Press the [Stop/Unlock] key for 1 second or
more to open the cover. When set to the profes-
sional mode, it is not necessary to hold down
the [Stop/Unlock] key.
⓬
Press the [Stop/Unlock] key for 1 second or
more to open the cover. When set to the profes-
sional mode, it is not necessary to hold down
the [Stop/Unlock] key.
➏ ⓭
➐ ⓮
4
Fixing ink (Fix )