17
Installation Procedure
1. PREPARE PRINTER ENVIRONMENT
• Reliable Power source/outlet. Consider using a UPS if your area’s power is unreliable
• Electronic hygrometer/thermometer (to monitor the relative humidity of the room the printer is operating in).
Keep it near the printer at all times 15°C to 32°C (59°F to 90 °F).
• Humidifier to increase humidity if it falls below 45% humidity. Humidity needs to remain between 45% to
80% RH, non-condensing.
• Heat Press or tunnel dryer for heat curing the ink (THIS NEEDS ITS OWN CIRCUIT)
• Stable, Sturdy, and Level Table for the 81.6 kg (180 lb.) printer.
• PC computer with Windows 7, Windows 8.1 or Windows 10 operating system.
• Graphics software installed in the PC, such as Photoshop, CorelDraw, Photoshop Elements or Illustrator.
• High Volume Low Pressure (HVLP) electric sprayer or other type of sprayer for applying pretreatment for
dark garments.
• Use at an altitude of 2000 m or less.
• Keep shipping box right side up (see arrows)
• Remove poly wrap and strapping
• Remove top lid, upper foam and separator sleeve
• DO NOT LIFT BY PRINT TABLE FRAME, LIFT FROM BOX WITH HELP OF 4 PEOPLE
• Place printer on your table
• Unlatch top cover by pressing button below control panel (see diagram) to lift top cover
• IMPORTANT! Remove BOTH shipping retainer brackets before powering on the printer. Remove the
3 thumb screws holding the Table and Print Carriage in position (See diagram below). Keep the brackets
and 3 thumb screws for future use for shipping your printer), you should now be able to move the table
carriage freely back and forth.
• Locate the six adjustable printer feet under the printer
• Open top cover. Place a “torpedostyle level” (included) on top of the front metal rail left to right. Adjust left
and right printer feet to level, then adjust middle foot for stability.
To Next Page
Loading...
