•
•
• (Needs replacing)
If [Toner End Option] is set to [Continue Printing], "**" is displayed instead of the indicator above.
Toner levels are not displayed for Type 3 models.
Low Humidity Mode
When the machine is used in a low humidity environment, black stripes with a few millimeters width
may appear. Selecting [On] should prevent such black stripes from appearing.
Default: [Off]
• On
• Off
Registration
Adjusts the position of the input tray. Adjust the value by using the [ ] or [ ] key.
To check the registration, print a test page.
Tray 1
Adjusts the position of Tray 1.
Default: [0]
• Horizontal (-6 to +6 mm, in 1 mm increments)
• Vertical (-6 to +6 mm, in 1 mm increments)
Bypass Tray
Adjusts the position of the bypass tray.
Default: [0]
• Horizontal (-6 to +6 mm, in 1 mm increments)
• Vertical (-6 to +6 mm, in 1 mm increments)
Adjust Image Density
Adjusts the density of printing.
Default:
• (Lightest)
•
•
•
•
•
System Settings
129
To Next Page
Loading...
