13
Control Panel Display Messages (SP C240SF/C242SF/C240DN/C242DN)
The following table lists the control panel display messages that can appear if
an error occurred during a firmware update, and explains the likely causes of
those messages and what action to take when they appear.
Message Likely cause Solution
Initializing If this message remains on the
control panel display for more
than one minute following
a firmware update, a power
failure or similar interruption
prevented the update from
completing.
See p.7 “If initialization does not
end following a firmware update”
and use the procedure shown
there to recover from the failure
and complete the update.
If the recovery fails and the indi-
cators continue to flash alternate-
ly, contact your sales or service
representative.
Control Panel Indicator Patterns (SP C240DN/C242DN)
The indicators of the control panel show the machine’s status during and after
firmware updates. If an update fails or does not complete normally, refer to the
following table to resolve the problem.
Indicator pattern Likely cause Solution
The Alert and Data
in indicators light up
simultaneously.
If the Alert and Data in indica-
tors light up simultaneously
after you turn the machine’s
power back on following a firm-
ware update, the update did not
complete due to a power failure
or similar interruption.
See p.7 “If initialization does
not end following a firmware
update” and use the procedure
shown there to recover from the
failure and complete the update.
If the recovery fails and the
indicators continue to flash
alternately, contact your sales or
service representative.
To Next Page
Loading...
