Ricoh THETA - Shooting Pictures; Taking Still Images; Shooting Remotely

Connecting to the Theta Wi-fi
1. Remove the USB connector from the Theta camera (the Wi-Fi can’t be enabled while it’s connected).
2. Turn on the Theta camera by briefly pressing the power button on the side.
3. LED’s will illuminate and the Wi-Fi icon above the camera icon will be flashing.
4. If the Wi-Fi icon is not flashing, press the 2nd button.
5. The Theta serial number is the default Wi-Fi password. (just the numbers NOT the “YL”).
Note: It is not advised to change the password as there is no password recovery feature.
6. The Theta camera will be visible in the list of available Wi-Fi sources as THETAYLXXXXXXXX.OSC. The X’s will
https://knowledge.faro.com/Hardware/2D_Scanners/ScanPlan/Configure_Ricoh_Theta_Cameras_For_ScanPlan
Updated: Sat, 05 Jun 2021 19:32:58 GMT
3